Timer Description Default
External Bell Delay
EXT BELL DELAY
This will cause a delayed activation of the external bell. (0–999
seconds)
0 sec.
External Bell Delay Partset Delay period before external bells are activated in partset mode. 0 sec
Chime
CHIME TIME
Number of seconds that a chime output will activate, when a
zone with chime attribute opens. (1–10 seconds)
2 sec.
Confirmation
Confirm
CONFIRM TIME
Note: This option is only available for certain Grade and
Confirmation option combinations. (See Options on page169
and Standards on page184.)
This timer applies to the alarm confirmation feature and is
defined as the maximum time between alarms from two
different non overlapping zones that will cause a confirmed
alarm. (0–60 minutes)
30 min.
Confirmed holdup Note: This option is only available for certain Grade and
Confirmation option combinations. (See Options on page169
and Standards on page184.)
This timer applies to the confirmed holdup feature and is
defined as the maximum time between alarms from two
different non-overlapping zones that will cause a confirmed
alarm. (480–1200 minutes)
480 min.
Dialer Delay
DIALER DELAY
When programmed, the dialler delay initiates a predefined delay
period before the system dials out to an Alarm Receiving Centre
(ARC). This is specifically designed to reduce unwarranted
responses from Alarm Receiving Centres and the constabulary.
In the event of a subsequent zone being tripped the dialler delay
period is ignored and the dialler dials out immediately. (0–999
seconds)
30 sec.
Partset Dialer Delay Delay period after a Partset alarm has been activated before
system makes a call to ARC.
30 sec
Alarm abort
ALARM ABORT
Time after a reported alarm in which an alarm abort message
can be reported. (0–999 seconds)
30 sec.
Setting
Setting Authorisation
SETTING AUTH
Period for which Setting Authorisation is valid. (10–250
seconds)
10 sec
Final Exit
FINAL EXIT
The Final Exit time is the number of seconds that arming is
delayed after a zone programmed with the final exit attribute is
closed. (1–45 seconds)
7 sec.
Bell on Fullset
FULLSET BELL
Activates the external bell momentarily to indicate a full set
condition. (0–10 seconds)
0 sec.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2023 72 I-200572
08.12.2023
To Next Page