Acre SPC42 - Page 85

Name Description
VISUAL
INDICATIONS
(Flexible mode
only)
Enables you to assign specific behaviour to each LED on the keyswitch expander. Each
of the LEDs has the following options:
l
FUNCTION — the following options are available:
– KEYSWITCH — select a keyswitch and the position of the key.
– DISABLED — select to disable the LED.
– SYSTEM — select the alarm type which triggers the LED.
– AREA — select the area which triggers the LED.
– ZONE — select the zone which triggers the LED
– DOOR — select the door and the door option which triggers the LED.
l
ON – COLOR — specify the activation colour
l
ON – FLASH — specify the behaviour of the LED in active state. Available options
are:
– Permanent — always on.
– Flash Fast/Medium/Slow — varying speed of the flashing.
l
OFF – COLOR — specify the deactivation colour.
l
OFF – FLASH — specify the behaviour of the LED in the inactive state. Available
options are:
– Permanent — always on.
l
Flash Fast/Medium/Slow — varying speed of the flashing.
DEACTIVATION
(Flexible mode
only)
Select a deactivation method from the available options:
l
Calendar — select a calendar.
KEY POSITIONS Enables you to assign behaviour to specific key positions for specific areas.
Select an area for the key position, and assign one of the following options to that area:
l
None
l
Unset
l
Partset A
l
Partset B
l
Fullset
l
Toggle Unset/Fullset
l
Toggle Unset/Partset A
l
Toggle Unset/Partset B
l
All Okay
l
Setting Authorisation
14.6.4.5 Edit Door Controllers
For further information about Door controllers, see Door Expander on page34.
1. Scroll to DOOR CONTROLLERS > EDIT.
2. Press SELECT.
3. Scroll to the device to be edited and press SELECT.
Parameters and details, if applicable, are displayed for editing as shown in the table below.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2023 85 I-200572
08.12.2023