EasyManua.ls Logo

Aeonmed Aeon8800A - Disassemble the Breathing System Block

Aeonmed Aeon8800A
183 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7.Cleaning, disinfection, and Sterilization
123
7.4.6. Disassemble the breathing system block
WARNING: Wear latex gloves during disassembly in case that operator’s hands get
damaged.
CAUTION: The assembly sequence of the breathing system is contrary to the
disassembly sequence, referring to this chapter.
7.4.6.1. Disassembly
Remove CGO assembly from the CGO interface.
Remove the O
2
sensor from breathing system.
Refer to chapter 7.4.2.
Remove the heater cable from the outlet module.

Table of Contents