Aeonmed Aeon8800A - Page 62

4.Pre-operative preparation
53
◼ Make sure AP1000 installs at a place where operator can get a clear view of it.
◼ Connect AP1000 according to the practical situation if no GCX rail is available on the
Anaesthetic Workstation.
◼ Make sure good connection in case of Anaesthesia gas leaks to operating room.
Step 1: A wide slot at the left side of Anaesthetic
Workstation specially designed for putting
AGSS; put AGSS to U-bracket.
Step 2:
Hold the AGSS with both hands ensuring the
fixity faces the wide slot. Slide AGSS
horizontally to rail till its limiting position.