New in this Manual
The following changes have been made in this revision of the manual:
Description
Section
Added hydraulic steel pump plate. Section – Install the Hydraulic Pump on page 52,
Section 3.20.3 – Install the Hydraulic Pump and
Clutch on page 71
Updated the following assembly sections:
• spout assembly • Section 3.10 – Install the Spout Roller on page 28
• motor mount frame and torsion idler assembly • Section 3.19 – Install Top-Mount Drive Overview
on page 47, Section 3.20 – Install the Under-
Mount Drive on page 66
• urethane flashing positioning • Section 3.23.4 – Straighten the Seals and Position
the Flashing on page 102
• spout brush assembly • Section 3.30 – Attach the Spout Brush on page
122
• throttle actuator • Section 3.39 – Gas Drive Control Box Wiring on
page 142
To Next Page
