8 8210-00020 R1
1.5.2 Electric Motor Safety
Power Source
• Electric motors and controls shall be installed and serviced by
a qualified electrician and must meet all local codes and
standards.
• Use a magnetic starter to protect the electric motor.
• You must have a manual reset button.
• Reset and motor starting controls must be located so that the
operator has full view of the entire operation.
• Locate main power disconnect switch within reach from
ground level to permit ready access in case of an emergency.
• Motor must be properly grounded.
• Ensure electrical wiring and cords remain in good condition;
replace if necessary.
S E R V I C E D I S C O N N E C T
ON
OFF
Lockout
• The main power disconnect switch should be in the locked position during shutdown or
whenever maintenance is performed.
• If reset is required, disconnect all power before resetting motor.
1. SAFETY FIELD LOADER S-DRIVE – PORTABLE GRAIN BELT CONVEYOR
To Next Page
Loading...
