8210-00020 R1 129
3.35. Install the Tube Lift Cable
1. Wrap the cable (1) around the bottom side of the winch drum with three complete wraps around the drum
when conveyor is in transport position (see Figure 63).
Failure to follow could result in conveyor collapse and cause serious injury.
2. Thread cable onto drum and secure with spool anchor.
Note
The nut must be on the outside of the drum to prevent damage to the cable.
3. Run the cable towards the spout.
4. Thread the cable through the slider pulley.
5. Run the cable from the slider pulley towards the hopper and stop at the cable attach (3).
6. Loop the cable under and around the cable attach and secure it with two 5/16" cable clamps (2).
7. Trim excess cable.
8. Test the function of the winch by lifting the conveyor to its raised position.
Crushing/impact hazard
Do not stand under the conveyor while testing the winch. The conveyor may drop
unexpectedly. Ensure all equipment and personnel are clear of the conveyor while testing
the winch.
The tube lift components may become damaged.
Stop the test if anything should slide, slip, or jam. Correct the issue before continuing.
Table 26. Tube Lift Cable Components
Item
Description
1
26' Cable 5/16" 7 x 19 GAC
2
5/16" Cable Clamp*
3
Small Cable Attach
*Hardware Kit: HRDW-15-124
FIELD LOADER S-DRIVE – PORTABLE GRAIN BELT CONVEYOR 3. ASSEMBLY
To Next Page
Loading...
