8-28 Agilent 4155B/4156B User’s Guide Vol.2, Edition 5
If You Have A Problem
If Errors Occur
185 ASCII format does not allow block transfer.
186 Block size mismatched with data format.
187 Y2 axis is not assigned.
188 List name is not assigned.
189 The specified name is not list name.
190 Illegal file type is requested.
191 System busy. Printing out hard copy.
192 Unable to set. Another controller is on bus.
193 Unable to specify this name here.
194 PGU Pulse DELAY must be >= setup res.
PGU pulse delay time must be ³ setup resolution.
195 Cal/Diag failed. Cannot use unit.
196 Compliance too low to force pulse.
197 Compliance too high to force pulse.
198 Two VPULSE PGUs must be same STBY.
199 Two VPULSE PGUs must be same FCTN.
200 Improper parameter for file operation.
An option for the file system command has been set up incorrectly.
201 System error. Filer memory overflow.
202 Filer error. Integer overflow.
203 Bad volume specifier.
Volume label for mass storage is incorrect. Initialization may have been
performed on an incompatible system, or the disk may be defective.
204 Filer error. File type is wrong.
205 Filer error. EOF found.
206 Filer error. EOR found.
207 File error. Illegal DISK parameter.
Illegal disk parameter was detected. The mass storage device is set up
incorrectly.
To Next Page
Loading...
Need help?
General
