EasyManuals Logo

Agilent Technologies 4155B User Manual

Agilent Technologies 4155B
414 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #401 background imageLoading...
Page #401 background image
Agilent 4155B/4156B User’s Guide Vol.2, Edition 5 8-27
If You Have A Problem
If Errors Occur
165 Set value is too small for range.
For LOG sweep measurement, start and stop value must be equal or
more than setup resolution. For sweep measurement, step value of
VAR1 and VAR2 must be equal or more than setup resolution.
166 PGU Peak/Base difference must be <= 40V
170 Use Sweep/Bias instead of SMU Pulse.
171 Knob Sweep sets VAR1' to CONST.
If you set VAR1' for knob sweep measurement, the VAR1' channel
forces a constant value equal to START value. VAR1' cannot be a
sweep source for Knob Sweep measurement.
172 Cannot do SAMPLING when Knob Sweep.
173 |STEP| must be <= |STOP-START|.
174 Cannot set CONT AT ANY if PCOMP is ON.
When you set power compliance, you cannot select CONT AT ANY
secondary softkey.
175 CONST setup must be <= unit output range.
176 Pulse BASE must be <= unit output range.
177 PGU pulse WIDTH must be >= setup res.
Pulse width of PGUs must be greater than or equal to unit setup
resolution.
178 TRIG OUT DELAY is too long.
Trigger out delay must be 32.7 ms or pulse width you specified,
whichever is shorter.
179 Cannot ENABLE stop if INIT INT < 2 ms.
When initial interval is set to less than 2 ms, you cannot set stop
condition.
180 Illegal setup. Target module is not installed.
181 Illegal setup. Invalid command.
182 Cannot define more than 6 User functions.
183 Cannot define more than 8 data vars in lists.
184 Cannot define more than 2 display data vars.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agilent Technologies 4155B and is the answer not in the manual?

Agilent Technologies 4155B Specifications

General IconGeneral
BrandAgilent Technologies
Model4155B
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals