8-32 Agilent 4155B/4156B User’s Guide Vol.2, Edition 5
If You Have A Problem
If Errors Occur
307 Cannot shutdown Power Supply.
Turn on the 4155B/4156B again. You can use filer functions after
selecting OK secondary softkey (except when this error occurs during
power-on test).
308 Unknown emergency (SMUC time out).
Perform 305: HOSTC <--> SMUC I/F test on the SYSTEM:
SELF-CALIBRATION/DIAGNOSTICS screen. If this test fails, the
4155B/4156B may need service. Contact the nearest Agilent
Technologies Sales and Service office.
309 The SMU AND PULSE GENERATOR EXPANDER is not
turned on.
Turn on the expander, then cycle mainframe power.
310 Unsupported unit detected in Slot ##. Turn off
the power and remove the unit.
The displayed unit must be changed. Contact the nearest Agilent
Technologies Sales and Service office.
320 Not enough memory. Cannot display >=200 files.
The 4155B/4156B cannot display more than 199 files on the FILE
CATALOG because of an internal memory limitation. If you create
more than 199 files, move the additional files to another directory.
321 Too many links.
The file has too many links. Remove extra links or use symbolic links.
322 File system down or network disconnected.
Unable to access the network directory. The file system was down or
the network was disconnected.
323 The network address is already used.
A process has already been bound to the address. The current process
must finish before the new process can use the address.
324 Change dir failed. File is not a directory.
Change directory failed because you specified a file, not a directory.
325 Unable to open file. Deadlock occurred.
Unable to open the file. Deadlock occurred in the resource where you
tried to open the file.
To Next Page
Loading...
Need help?
General
