8-34 Agilent 4155B/4156B User’s Guide Vol.2, Edition 5
If You Have A Problem
If Errors Occur
337 Cannot set 0.0.0.0 for 4155/4156 IP address.
When a valid host name for the 4155B/4156B network setup is
specified, the IP address of the 4155B/4156B cannot be set to
0.0.0.0.
338 Cannot set 0(zero) for 4155/4156 User ID.
When a valid host name for the 4155B/4156B network setup is
specified, the User Id of the 4155B/4156B cannot be set to 0 (zero).
339 No response from NFS. Try again ?
There is no response from the Network File System (NFS) when trying
to mount a network disk. Verify the network is operating properly and
the file export executed properly.
340 Host name must be <= 15 alphanumeric character.
The 4155B/4156B host name must be 15 or less alphanumeric
characters.
344 System busy. Cannot execute US/US42 command.
Unable to move to FLEX command control mode, because the US or
US42 command cannot be executed while system is busy; making
measurement, operating file functions, executing calibration or
diagnostics, printing, emergency, and so on.
345 Change display page. DISP OFF(0) is not allowed.
Unable to enter the :DISP OFF ( or 0) command when the
4155B/4156B screen displays System screen group or KNOB SWEEP
screen.
346 Enter DISP ON(1) to execute this command.
Unable to enter the :PAGE:KSW command group,
:PAGE:SCON:KSW command, or :DIAG:TEST test_no (test_no:
201 to 413) command when the 4155B/4156B screen is set to the
update disable state by the :DISP OFF (or 0) command.
350 Unable to transfer data. Name buffer full.
Cannot maintain the buffer required for transferring data.
351 File operation was interrupted by system call.
The lpr driver received a signal from the system, which interrupted an
open, read, or write operation.
To Next Page
Loading...
Need help?
General
