To set the analyzer’s network address
1. Ask your network administrator to assign an Internet Protocol (IP) address to
your analyzer. Write down the address for use in step 4.
2. If your analyzer must communicate with computers outside of the local subnet,
ask your network administrator for the IP address and subnet mask required to
route data through the local gateway. Write down these values for use in steps
5 and 6.
3. On the analyzer, press [
Local/Setup
], [
LAN setup
], [
LAN port setup
].
4. Press [
IP address
], type the address obtained in step 1, then press [
enter
].
5. If you obtained a gateway address in step 2, press [
gateway IP
], type the address,
then press [
enter
].
6. If you obtained a mask value in step 2, press [
subnet mask
], type the value, then
press [
enter
].
7. Turn off the analyzer, then turn it back on to make the new settings permanent.
You must enter the addresses and the subnet mask using dotted decimal
notation (for example, 13.1.212.66). You can disable gateway routing by
setting [
gateway IP
]or[
subnet mask
] to 0.0.0.0.
Using the LAN (Options UTH & UG7)
14 - 4
To Next Page
Loading...
Need help?
General
