To select the remote X-Windows server
1. Determine the IP address of the computer you will use for remote X-Windows
operation. (Ask your network administrator for help if you don’t know how to
do this.) Write down the address for use in step 3.
2. Press [
Local/Setup
], [
LAN setup
].
3. Press [
X11 IP address
], type the address obtained in step 1, then press [
enter
].
After you have attached the analyzer to the network and configured it as
described in the previous two tasks, you can operate it remotely from any
computer that is attached to the network and running X-Windows. This
task shows you how to select the computer you want to use for remote
operation. The next task shows you how to initiate remote operation.
Remote X-Windows is available only in analyzers that have options UTH
and UG7. To determine if your analyzer has these options, see this task:
“To determine if you have options UTH and UG7.”
Using the LAN (Options UTH & UG7)
14 - 7
To Next Page
Loading...
Need help?
General
