TABLE OF CONTENTS
1 Demodulating an Analog Signal
To perform AM demodulation 1-2
To perform PM demodulation 1-4
To perform FM demodulation 1-6
2 Measuring Phase Noise
To measure phase noise 2-2
Special Considerations for phase noise measurements: 2-3
3 Characterizing a Transient Signal
To set up transient analysis 3-2
To analyze a transient signal with time gating 3-4
To analyze a transient signal with demodulation 3-5
4 Making On/Off Ratio Measurements
To set up time gating 4-2
To measure the on/off ratio 4-4
5 Making Statistical Power Measurements
To display CCDF 5-2
To display peak, average, and peak/average statistics 5-4
6 Creating Arbitrary Waveforms
To create a waveform using a single, measured trace 6-2
To create a waveform using multiple, measured traces 6-4
To create a short waveform using ASCII data 6-6
To create a long waveform using ASCII data 6-8
To create a contiguous waterfall or spectrogram display 6-10
To create a fixed-length waterfall display 6-12
To determine number of samples and ∆t 6-14
To output the maximum number of samples 6-15
xix
To Next Page
Loading...
