To initiate remote X-Windows operation
1. Confirm that the previous six tasks have been completed.
2. On the remote computer (selected in the previous task), position the mouse
pointer in one of the windows, then enter the following command: xhost +
3. On the analyzer, press [
Local/Setup
], [
LAN setup
].
4. Press [
X11 display
] to display “on.”
5. On the remote computer, use the mouse to position the outline of the remote
X11 display, then click the left mouse button to continue.
When you complete this task, the outline of the remote X11 display is filled
in with a replica of the analyzer’s front panel. The computer maintains this
replica by using its LAN connection to get the latest trace, and state
information, from the analyzer.
You may find that the computer responds more slowly to other processes
(for example, key presses and mouse movements) while it is maintaining
the X11 display. If it responds too slowly, you can decrease the value of
[
rate limit
], which is located under [
Local/Setup
], [
LAN setup
]. This allows the
analyzer to respond more quickly to other processes by reducing the
amount of time it spends maintaining the X11 display.
Remote X-Windows is available only in analyzers that have options UTH
and UG7. To determine if your analyzer has these options, see this task:
“To determine if you have options UTH and UG7.”
Using the LAN (Options UTH & UG7)
14 - 8
To Next Page
Loading...
Need help?
General
