Alcatel-Lucent 7210 SAS M - Page 364

VPLS Services Command Reference
Page 364 7210 SAS M Services Guide
Mesh SDP Commands
Note: Mesh SDP commands are not supported by 7210 SAS-M devices configured in Access uplink
mode.
config
—service
— [no] vpls service-id [customer customer-id] [create] [vpn vpn-id]
[mvpls] [create] [vpn vpn-
id] [m-vpls] (for 7210 SAS-M in Network mode)
— [no] vpls service-id [customer customer-id] [create] [vpn vpn-id]
[mvpls] service-id [cus-
tomer customer-id] [create] [vpn vpn-id] [m-vpls] [svc-sap-type {null-star|dot1q-pre-
serve|any}] [customer-vid vlan-id] (for 7210 SAS-M in Access uplink mode)
— mesh-sdp sdp-id[:vc-id] [vc-type {ether | vlan}]
—no mesh-sdp sdp-id[:vc-id]
— accounting-policy acct-policy-id
—no accounting-policys
— [no] collect-stats
— [no] control-word
— description description-string
—no description
— egress
—no vc-label [egress-vc-label]
— eth-cfm
— mep mep-id domain md-index association ma-index [direction
{up}{down}]
—no mep
mep-id domain md-index association ma-index
— [no] ais-enable
— client-meg-level [[level [level...]]
— no client-meg-level
— interval {1 | 60}
— no interval
— priority priority-value
— no priority
— [no] ccm-enable
— ccm-ltm-priority priority
—no ccm-ltm-priority
— [no] description description-string
— [no] eth-test-enable
— bit-error-threshold bit-errors
— test-pattern {all-zeros | all-ones} [crc-enable]
—no test-pattern
— low-priority-defect {allDef | macRemErrXcon |
remErrXcon | errXcon | xcon | noXcon}
— mac-address mac-address
—no
mac-address
— one-way-delay-threshold seconds
— [no] shutdown
— [no] force-vlan-vc-forwarding
— igmp-snooping
— [no] fast-leave
— import policy-name
—no import
— last-member-query-interval interval
—no last-member-query-interval
— max-num-groups max-num-groups