Alcatel-Lucent 7210 SAS M - Page 366

VPLS Services Command Reference
Page 366 7210 SAS M Services Guide
Spoke SDP Commands
Note: Spoke SDP commands are not supported by 7210 SAS-M devices configured in Access uplink
mode.
config
—service
— [no] vpls service-id [customer customer-id] [create] [vpn vpn-id]
[mvpls] (for 7210 SAS-M
in Network mode)
— [no] vpls service-id [customer customer-id] [create] [vpn vpn-id]
[mvpls] [d>] [m-vpls]
[svc-sap-type {null-star|dot1q-preserve|any}] [customer-vid <vlan-id>] (for 7210 SAS-M in
Access uplink mode)
— spoke-sdp sdp-id[:vc-id] [vc-type {ether | vlan}] [create] [split-horizon-group
group-name] endpoint endpoint-name
—no spoke-sdp sdp-id[:vc-id]
— accounting-policy acct-policy-id
—no accounting-policy
— [no] block-on-mesh-failure
— bpdu-translation {auto | pvst | stp}
—no bpdu-translation
— [no] collect-stats
— [no] control-word
— description description-string
—no description
— [no] disable-aging
— [no] disable-learning
— [no] discard-unknown-source
— eth-cfm
— mep
mep-id domain md-index association ma-index [direction
{up}{down}]
—no mep mep-id domain md-index association ma-index
— [no] ais-enable
— client-meg-level [[level [level...]]
— no client-meg-level
— interval {1 | 60}
— no interval
— priority priority-value
— no priority
— [no] ccm-enable
— ccm-ltm-priority priority
—no ccm-ltm-priority
— [no] description description string
— [no] eth-test-enable
— bit-error-threshold bit-errors
— test-pattern {all-zeros | all-ones} [crc-enable]
—no test-pattern
— low-priority-defect {
allDef | macRemErrXcon |
remErrXcon | errXcon | xcon | noXcon}
— mac-address mac-address
—no mac-address
— one-way-delay-threshold seconds
— [no] shutdown
— egress
— vc-label egress-vc-label
—no vc-label [egress-vc-label]