VPRN Service Configuration Commands
Page 1050 7750 SR OS Services Guide
protocol interface is tied to the state of the BFD session between the local node and the remote node.
The parameters used for the BFD are set via the BFD command under the IP interface.
The no form of this command removes BFD from the associated IGP protocol adjacency.
Default no bfd-enable
bsm-check-rtr-alert
Syntax [no] bsm-check-rtr-alert
Context config>service>vprn>pim>interface
Description This command enables the checking of router alert option in the bootstrap messages received on this
interface.
Default no bsm-check-rtr-alert
hello-interval
Syntax hello-interval hello-interval
no hello-interval
Context config>service>vprn>pim>interface
config>service>vprn>pim>mdt>default
Description This command configures the frequency at which PIM Hello messages are transmitted on this
interface.
The no form of this command reverts to the default value.
Default 30
Parameters hello-interval — Specifies the hello interval in seconds. A 0 (zero) value disables the sending of hello
messages.
Values 0 — 255 seconds
hello-multiplier
Syntax hello-multiplier deci-units
no hello-multiplier
Context config>service>vprn>pim>interface
config>service>vprn>pim>mdt>default
Description This command configures the multiplier to determine the holdtime for a PIM neighbor.
The hello-multiplier in conjunction with the hello-interval determines the holdtime for a PIM
neighbor.
Parameters deci-units — Specify the value, specified in multiples of 0.1, for the formula used to calculate the
hello-holdtime based on the hello-multiplier:
To Next Page
Loading...
