Virtual Private Routed Network Services
7750 SR OS Services Guide Page 1067
The no form of the command used at the global level reverts to the default value.
The no form of the command used at the group level reverts to the value defined at the global level.
The no form of the command used at the neighbor level reverts to the value defined at the group level.
Default 120 seconds
Parameters seconds — The BGP Connect Retry timer value in seconds, expressed as a decimal integer.
Values 1 — 65535
damping
Syntax [no] damping
Context config>service>vprn>bgp
config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
Description This command enables BGP route damping for learned routes which are defined within the route
policy. Use damping to reduce the number of update messages sent between BGP peers and reduce
the load on peers without affecting the route convergence time for stable routes. Damping parameters
are set via route policy definition.
The no form of the command used at the global level disables route damping.
The no form of the command used at the group level reverts to the value defined at the global level.
The no form of the command used at the neighbor level reverts to the value defined at the group level.
When damping is enabled and the route policy does not specify a damping profile, the default
damping profile is used. This profile is always present and consists of the following parameters:
Half-life: 15 minutes
Max-suppress: 60 minutes
Suppress-threshold: 3000
Reuse-threshold 750
Default no damping — Learned route damping is disabled.
disable-client-reflect
Syntax [no] disable-client-reflect
Context config>service>vprn>bgp
config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
Description This command disables the reflection of routes by the route reflector to the group or neighbor.
This only disables the reflection of routes from other client peers. Routes learned from non-client
peers are still reflected to all clients.
The no form re-enables client reflection of routes.
Default no disable-client-reflect — Client routes are reflected to all client peers.
To Next Page
Loading...
