VPRN Service Configuration Commands
Page 1112 7750 SR OS Services Guide
sap-using [ingress | egress] qos-policy qos-policy-id
sap-using authentication-policy policy-name
Context show>service
Description Displays SAP information.
If no optional parameters are specified, the command displays a summary of all defined SAPs.
The optional parameters restrict output to only SAPs matching the specified properties.
Parameters ingress — Specifies matching an ingress policy.
egress — Specifies matching an egress policy.
qos-policy qos-policy-id — The ingress or egress QoS Policy ID for which to display matching
SAPs.
Values 1 — 65535
atm-td-profile td-profile-id — Displays SAPs using this traffic description.
filter filter-id — The ingress or egress filter policy ID for which to display matching SAPs.
Values 1 — 65535
port-id — Specifies the physical port ID in the slot/mda/port format.
If the card in the slot has Media Dependent Adapters (MDAs) installed, the port-id must be in the
slot_number/MDA_number/port_number format. For example 6/2/3 specifies port 3 on MDA 2
in slot 6.
The port-id must reference a valid port type. When the port-id parameter represents SONET/
SDH and TDM channels, the port ID must include the channel ID. A period “.” separates the
physical port from the channel-id. The port must be configured as an access port.
Values
qtag1 0 — 4094
qtag2 *, 0 — 4094
vpi NNI 0 — 4095
UNI 0 — 255
vci 1, 2, 5 — 65535
dlci 16 — 1022
bundle-id — Specifies the multilink bundle to be associated with this IP interface. The bundle key-
word must be entered at the beginning of the parameter.
The command syntax must be configured as follows:
bundle-id: bundle-type-slot-id/mda-slot.bundle-num
bundle-id value range: 1 — 128
For example:
*A:ALA-12>config# port bundle-ima-5/1.1
*A:ALA-12>config>port# multilink-bundle
ima — Specifies Inverse Multiplexing over ATM. An IMA group is a collection of physical links
bundled together and assigned to an ATM port.
qtag1, qtag2 — Specifies the encapsulation value used to identify the SAP on the port or sub-port. If
this parameter is not specificially defined, the default value is 0.
To Next Page
Loading...
