OAM and SAA
7750 SR OS Services Guide Page 1385
VPLS MAC diagnostic commands
mac-ping
In-band and out-of-band utility to determine the existence of an egress SAP bind-
ing of a given MAC within a VPLS. Utility can also be used to display all opera-
tionally up SAPs in the VPLS service.
1438
cpe-ping
In-band and out-of-band utility to determine connectivity to a given IP address
within a VPLS.
mac-populate
Populates the FIB with an OAM-type MAC entry indicating the node is the
egress node for the MAC address and optionally floods the OAM MAC associa-
tion throughout the service.
1418
mac-purge
Removes an OAM-type MAC entry from the FIB and optionally floods the
OAM MAC removal throughout the service.
1421
mac-trace
In-band or out-of-band utility to determine the hop-by-hop path for a destination
MAC address within a VPLS.
1440
IGMP snooping diagnostic commands
mfib-ping
In-band utility to determine the list of SAPs which egress a certain IP multicast
stream (identified by source unicast and destination multicast IP addresses)
within a VPLS. Utility can also be used to display all SAPs which are operation-
ally up in the VPLS service.
1422
SAA configuration commands
config>saa>test
description
Description for this SAA test. 1426
jitter-event
At the termination of an SAA test, both rising and falling thresholds are evalu-
ated versus the configuration and events generated as required.
1427
latency-event
At the termination of an SAA test, both rising and falling thresholds are evalu-
ated versus the configuration and events generated as required.
1427
loss-event
At the termination of an SAA test, both rising and falling thresholds are evalu-
ated versus the configuration and events generated as required.
1428
shutdown/
no shutdown
In order to modify an existing test it must be shut down first. When a test is cre-
ated it is in shutdown mode until a no shutdown command is executed.
1395
VLL diagnostic commands
vccv-ping
Configures a Virtual Circuit Connectivity Verification (VCCV) test. 1449
Table 1: OAM Command Summary (Continued)
Command Description Page
To Next Page
Loading...
