Alcatel-Lucent 7750 SR OS - Page 1402

OAM and SAA Command Reference
Page 1404 7750 SR OS Services Guide
Unlike sdp-ping, only a single message will be sent per command; no count nor interval parameter is
supported and round trip time is not calculated. A timeout value of 10 seconds is used before failing
the request. The forwarding class is assumed to be Best-Effort Out-of-Profile
If no request is sent or a reply is not received, all remote information will be shown as N/A.
To terminate a svc-ping in progress, use the CLI break sequence <Ctrl-C>.
Upon request timeout, message response, request termination, or request error the following local and
remote information will be displayed. Local and remote information will be dependent upon service
existence and reception of reply.
Field Description Values
Request Result The result of the svc-ping request message. Sent - Request Timeout
Sent - Request Terminated
Sent - Reply Received
Not Sent - Non-Existent
Service-ID
Not Sent - Non-Existent
SDP for Service
Not Sent - SDP For Service
Down
Not Sent - Non-existent
Service Egress Label
Service-ID The Service-ID being tested. service-id
Local Service Type The type of service being tested. If service-id does not exist
locally, N/A is displayed.
Epipe, Ipipe, Fpipe, Apipe
TLS
IES
Mirror-Dest
N/A
Local Service Admin
State
The local administrative state of service-id. If the service does
not exist locally, the administrative state will be Non-Existent.
Admin-Up
Admin-Down
Non-Existent
Local Service Oper State The local operational state of service-id. If the service does not
exist locally, the state will be N/A.
Oper-Up
Oper-Down
N/A