OAM and SAA Command Reference
7750 SR OS Services Guide Page 1403
Default 5
Values 1 — 10
interval seconds — The interval parameter in seconds, expressed as a decimal integer. This
parameter is used to override the default request message send interval and defines the minimum
amount of time that must expire before the next message request is sent.
If the interval is set to 1 second, and the timeout value is set to 10 seconds, then the maximum
time between message requests is 10 seconds and the minimum is 1 second. This depends upon
the receipt of a message reply corresponding to the outstanding message request.
Default 1
Values 1 — 10
Output Sample SDP MTU Path Test Sample Output
*A:router 1> sdp-mtu 6 size-inc 512 3072 step 256
Size Sent Response
------- ---- ---------------------------
512 . Success
768 . Success
1024 . Success
1280 . Success
1536 . Success
1792 . Success
2048 . Success
2304 … Request Timeout
2560 … Request Timeout
2816 … Request Timeout
3072 … Request Timeout
Maximum Response Size: 2048
svc-ping
Syntax svc-ping ip-address [service service-id] [local-sdp] [remote-sdp]
Context <GLOBAL>
Description Tests a service ID for correct and consistent provisioning between two service end points.
The svc-ping command accepts a far-end IP address and a Service-ID for local and remote service
testing. The following information can be determined from svc-ping:
1. Local and remote service existence
2. Local and remote service state
3. Local and remote service type correlation
4. Local and remote customer association
5. Local and remote service-to-SDP bindings and state
6. Local and remote ingress and egress service label association
To Next Page
Loading...
