OAM and SAA Command Reference
Page 1406 7750 SR OS Services Guide
Responders Expected
Far-end Address
The expected source of the originator’s SDP-ID from the per-
spective of the remote 7750 SR terminating the SDP-ID. If the
far-end cannot detect the expected source of the ingress SDP-ID
or the request is transmitted outside the SDP-ID, N/A is dis-
played.
resp-rec-tunnel-far-end-
address
N/A
Originating SDP-ID The SDP-ID used to reach the far-end IP address if sdp-path is
defined. The originating SDP-ID must be bound to the service-id
and terminate on the far-end IP address. If an appropriate origi-
nating SDP-ID is not found, Non-Existent is displayed.
orig-sdp-id
Non-Existent
Originating SDP-ID
Path Used
Whether the Originating 7750 SR used the originating SDP-ID
to send the svc-ping request. If a valid originating SDP-ID is
found, operational and has a valid egress service label, the origi-
nating 7750 SR should use the SDP-ID as the requesting path if
sdp-path has been defined. If the originating 7750 SR uses the
originating SDP-ID as the request path, Yes is displayed. If the
originating 7750 SR does not use the originating SDP-ID as the
request path, No is displayed. If the originating SDP-ID is non-
existent, N/A is displayed.
Yes
No
N/A
Originating SDP-ID
Administrative State
The local administrative state of the originating SDP-ID. If the
SDP-ID has been shutdown, Admin-Down is displayed. If the
originating SDP-ID is in the no shutdown state, Admin-Up is
displayed. If an originating SDP-ID is not found, N/A is dis-
played.
Admin-Up
Admin-Up
N/A
Originating SDP-ID
Operating State
The local operational state of the originating SDP-ID. If an orig-
inating SDP-ID is not found, N/A is displayed.
Oper-Up
Oper-Down
N/A
Originating SDP-ID
Binding Admin State
The local administrative state of the originating SDP-IDs bind-
ing to service-id. If an SDP-ID is not bound to the service, N/A
is displayed.
Admin-Up
Admin-Up
N/A
Originating SDP-ID
Binding Oper State
The local operational state of the originating SDP-IDs binding to
service-id. If an SDP-ID is not bound to the service, N/A is dis-
played.
Oper-Up
Oper-Down
N/A
Responding SDP-ID The SDP-ID used by the far end to respond to the svc-ping
request. If the request was received without the sdp-path param-
eter, the responding 7750 SR will not use an SDP-ID as the
return path, but the appropriate responding SDP-ID will be dis-
played. If a valid SDP-ID return path is not found to the originat-
ing 7750 SR that is bound to the service-id, Non-Existent is
displayed.
resp-sdp-id
Non-Existent
Field Description Values (Continued)
To Next Page
Loading...
