Alcatel-Lucent 7750 SR OS - Page 197

Virtual Leased Line Services
7750 SR OS Services Guide Page 197
exit
spoke-sdp 6:600 endpoint "y" create
precedence 0
exit
no shutdown
----------------------------------------------
*A:ALA-T-PE2>config>service>epipe#
S-PE1: Note that specifying the vc-switching parameter enables a VC cross-connect so the
service manager does not signal the VC label mapping immediately but will put this into passive
mode.
Example:config>service# epipe 1 customer 1 vc-switching create
config>service>epipe# spoke-sdp 2:200 create
config>service>epipe>spoke-sdp$ no shutdown
config>service>epipe>spoke-sdp$ exit
config>service>epipe# spoke-sdp 3:300 create
config>service>epipe>spoke-sdp$ no shutdown
config>service>epipe>spoke-sdp$ exit
config>service>epipe# no shutdown
The following example displays the configuration:
*A:ALA-S-PE1>config>service>epipe# info
----------------------------------------------
...
spoke-sdp 2:200 create
exit
spoke-sdp 3:300 create
exit
no shutdown
----------------------------------------------
*A:ALA-S-PE1>config>service>epipe#
S-PE2: Note that specifying the vc-switching parameter enables a VC cross-connect so the
service manager does not signal the VC label mapping immediately but will put this into passive
mode.
Example:config>service# epipe 1 customer 1 vc-switching create
config>service>epipe# spoke-sdp 2:200 create
config>service>epipe>spoke-sdp$ no shutdown
config>service>epipe>spoke-sdp$ exit
config>service>epipe# spoke-sdp 3:300 create
config>service>epipe>spoke-sdp$ no shutdown
config>service>epipe>spoke-sdp$ exit
config>service>epipe# no shutdown