Alcatel-Lucent 7750 SR OS - Page 236

VLL Service Configuration Commands
Page 236 7750 SR OS Services Guide
apipe
Syntax apipe service-id [customer customer-id] [vpn vpn-id] [vc-type {atm-vcc | atm-sdu | atm-
vpc | atm-cell}] [vc-switching]
no apipe service-id
Context config>service
Description The Apipe service provides a point-to-point L2 VPN connection to a remote SAP or to another local
SAP. An Apipe can connect an ATM or Frame Relay endpoint either locally or over a PSN to a
remote endpoint of the same type or of a different type and perform interworking between the two
access technologies.
Parameters service-id — The unique service identification number identifying the service in the service domain.
This ID must be unique to this service and may not be used for any other service of any type. The
service-id must be the same number used for every 7750 SR on which this service is defined.
service-id
Values 1 — 2147483647
customer
customer customer-id — Specifies the customer ID number to be associated with the service. This
parameter is required on service creation and optional for service editing or deleting.
Values 1 — 2147483647
vpn vpn-id — Specifies the VPN ID number which allows you to identify virtual private networks
(VPNs) by a VPN identification number.
vpn-id
Values 1 — 2147483647
Default null (0)
vc-type — Specifies a 15 bit value that defines the type of the VC signaled to the peer. Its values are
defined in draft-ietf-pwe3-iana-allocation and it defines both the signaled VC type as well as the
resulting datapath encapsulation over the Apipe.
vc-type
Values atm-vcc, atm-sdu, atm-vpc, atm-cell
Default atm-sdu
vc-switching — Specifies if the pseudowire switching signalling is used for the spoke SDPs
configured in this service.
fpipe
Syntax fpipe service-id [customer customer-id] [vpn vpn-id] [vc-type {fr-dlci}] [vc-switching]
no fpipe service-id
Context config>service
Description This command configures an Fpipe service. An Fpipe provides a point-to-point L2 VPN connection
to a remote SAP or to another local SAP. A Fpipe connects only Frame Relay endpoints either locally
or over a PSN to a remote endpoint of the same type.