VLL Service Configuration Commands
Page 294 7750 SR OS Services Guide
Max Drop Count
Specifies the maximum number of consecutive SDP Echo Request
messages that can be unacknowledged before the keepalive protocol
reports a fault.
Hold Down Time
Specifies the amount of time to wait before the keepalive operating
status is eligible to enter the alive state.
SDP Delivery
Mechanism
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the Far End field.
If the SDP type is GRE, then the following message displays:
SDP Delivery Mechanism is not MPLS
Number of SDPs
The total number SDPs applied to this service ID.
Service Access Points
Service Id
The service identifier.
Port Id
The ID of the access port where this SAP is defined.
Description
Generic information about the SAP.
Encap Value
The value of the label used to identify this SAP on the access port.
Admin State
The desired state of the SAP.
Oper State
The operating state of the SAP.
Last Changed
The date and time of the last change.
Admin MTU
The desired largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
Oper MTU
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
Ingress qos-pol-
icy
The SAP ingress QoS policy ID.
Egress qos-policy
The SAP egress QoS policy ID.
Ingress Filter-Id
The SAP ingress filter policy ID.
Egress Filter-Id
The SAP egress filter policy ID.
Multi Svc Site
Indicates the multi-service site that the SAP is a member of.
Ingress sched-
policy
Indicates the ingress QoS scheduler for the SAP.
Egress sched-pol-
icy
Indicates the egress QoS scheduler for the SAP.
Acct. Pol
Indicates the accounting policy applied to the SAP.
Label Description (Continued)
To Next Page
Loading...
