Alcatel-Lucent 7750 SR OS - Page 402

Configuring a VPLS Service with CLI
Page 402 7750 SR OS Services Guide
Use the following CLI syntax to configure spoke SDP bindings:
Spoke SDP
CLI Syntax: config>service# vpls service-id
spoke-sdp sdp-id:vc-id [vc-type {ether|vlan}] [split-hori-
zon-group group-name]
egress
filter {ip ip-filter-id|mac mac-filter-id}
vc-label egress-vc-label
ingress
filter {ip ip-filter-id|mac mac-filter-id}
vc-label ingress-vc-label
limit-mac-move[non-blockable]
vlan-vc-tag 0..4094
no shutdown
static-mac ieee-address
stp
path-cost stp-path-cost
priority stp-priority
no shutdown
vlan-vc-tag [0..4094]
The following example displays the command usage to configure the spoke and mesh SDPs
displayed in Figure 43 on page 401.
Example: *A:ALA-1>config>service# vpls 9000
*A:ALA-1>config>service>vpls# mesh-sdp 5 create
*A:ALA-1>config>service>vpls> mesh-sdp# no shutdown
*A:ALA-1>config>service>vpls> mesh-sdp# exit
*A:ALA-1>config>service>vpls# mesh-sdp 7 create
*A:ALA-1>config>service>vpls> mesh-sdp# no shutdown
*A:ALA-1>config>service>vpls> mesh-sdp# exit
*A:ALA-1>config>service>vpls# spoke-sdp 2:22 create
*A:ALA-1>config>service>vpls> spoke-sdp# no shutdown
*A:ALA-1>config>service>vpls> spoke-sdp# exit
*A:ALA-1>config>service>vpls#
*A:ALA-2>config>service# vpls 9000
*A:ALA-2>config>service>vpls# mesh-sdp 5 create
*A:ALA-2>config>service>vpls> mesh-sdp# no shutdown
*A:ALA-2>config>service>vpls> mesh-sdp# exit
*A:ALA-2>config>service>vpls# mesh-sdp 7 create
*A:ALA-2>config>service>vpls> mesh-sdp# no shutdown
*A:ALA-2>config>service>vpls> mesh-sdp# exit
*A:ALA-2>config>service>vpls# spoke-sdp 2:22 create
*A:ALA-2>config>service>vpls> spoke-sdp# no shutdown
*A:ALA-2>config>service>vpls> spoke-sdp# exit
*A:ALA-2>config>service>vpls#