Virtual Private LAN Services
7750 SR OS Services Guide Page 535
Default none
Parameters grp-address — Specifies an IGMP multicast group address that receives data on an interface. The IP
address must be unique for each static group.
group-policy
Syntax group-policy policy-name
no group-policy
Context config>service>vpls>snooping>mvr
Description Identifies filter policy of multicast groups to be applied to this MVR VPLS. The sources of the
multicast traffic must be a member of the MVR VPLS.
The no form of the command removes the MVR policy association from the VPLS.
Default No group policy is specified.
Parameters policy-name — The group policy name. Allowed values are any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes. Routing policies are
configured in the config>router>policy-options context. The router policy must be defined
before it can be imported. For details on IGMP policies, please see section "Enabling IGMP
group membership report filtering" in the 7750 SR OS Router Configuration Guide.
igmp-snooping
Syntax igmp-snooping
Context config>service>vpls
config>service>vpls>sap
config>service>vpls>spoke-sdp
config>service>vpls>mesh-sdp
Description This command enables the Internet Group Management Protocol (IGMP) snooping context.
Default none
import
Syntax import policy-name
no import
Context config>service>vpls>sap>snooping
config>service>vpls>spoke-sdp>snooping
config>service>vpls>mesh-sdp>snooping
Description This command specifies the import routing policy to be used for IGMP packets to be used on this
SAP or SDP. Only a single policy can be imported on a single SAP at any time.
The no form of the command removes the policy association from the SAP or SDP.
To Next Page
Loading...
