VPLS Service Configuration Commands
Page 536 7750 SR OS Services Guide
Default no import — No import policy is specified.
Parameters policy-name — The import policy name. Allowed values are any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes. Routing policies are
configured in the config>router>policy-options context The router policy must be defined before
it can be imported.
last-member-query-interval
Syntax last-member-query-interval tenths-of-seconds
no last-member-query-interval
Context config>service>vpls>sap>snooping
config>service>vpls>spoke-sdp>snooping
config>service>vpls>mesh-sdp>snooping
Description This command configures the maximum response time used in group-specific queries sent in
response to ‘leave’messages, and is also the amount of time between 2 consecutive group-specific
queries. This value may be tuned to modify the leave latency of the network. A reduced value results
in reduced time to detect the loss of the last member of a group.
The configured last-member-query-interval is ignored when fast-leave is enabled on the SAP or SDP.
Default 10
Parameters seconds — Specifies the frequency, in tenths of seconds, at which query messages are sent.
Values 1 — 50
mcac
Syntax mcac
Context config>service>vpls>mesh-sdp>snooping
config>service>vpls>spoke-sdp>snooping
config>service>vpls>sap>snooping
Description This command configures multicast CAC policy and constraints for this interface.
Default none
policy
Syntax policy policy-name
no policy
Context config>service>vpls>mesh-sdp>snooping>mcac
config>service>vpls>spoke-sdp>snooping>mcac
config>service>vpls>sap>snooping>mcac
Description This command configures the multicast CAC policy name.
To Next Page
Loading...
