VPLS Service Configuration Commands
Page 542 7750 SR OS Services Guide
Static (s,g) entries can not be entered when a starg is already created.
Use the no form of the command to remove the source from the configuration.
Default none
Parameters ip-address — Specifies the IPv4 unicast address.
starg
Syntax [no] starg
Context config>service>vpls>sap>snooping>static>group
config>service>vpls>spoke-sdp>snooping>static>group
config>service>vpls>mesh-sdp>snooping>static>group
Description This command adds a static (*,g) entry to allow multicast traffic for the corresponding multicast
group from any source. This command can only be enabled if no existing source addresses for this
group are specified.
Use the no form of the command to remove the starg entry from the configuration.
Default no starg
static
Syntax static
Context config>service>vpls>sap>snooping
config>service>vpls>spoke-sdp>snooping
config>service>vpls>mesh-sdp>snooping
Description This command enables access to the context to configure static group addresses. Static group
addresses can be configured on a SAP or SDP. When present either as a (*, g) or a (s,g) entry,
multicast packets matching the configuration will be forwarded even if no join message was
registered for the specific group.
Default none
version
Syntax version version
no version
Context config>service>vpls>sap>snooping
config>service>vpls>mesh-sdp>snooping
config>service>vpls>spoke-sdp>snooping
Description This command specifies the version of IGMP which is running on this SDP or SAP. This object can
be used to configure a router capable of running either value. For IGMP to function correctly, all
routers on a LAN must be configured to run the same version of IGMP on that LAN.
To Next Page
Loading...
