List of Commands
Page 60 7750 SR OS Services Guide
scheduler
Defines bandwidth controls that limit each child (other schedulers and
queues) associated with the scheduler
86
rate
Defines the maximum bandwidth that the scheduler can offer its child
queues or schedulers.
87
scheduler-policy
Applies an existing scheduler policy to an ingress or egress scheduler
used by SAP queues associated with this multi-service customer site.
88
phone
Adds phone number information for a customer ID. 82
Configuring an SDP 68
config>service# sdp sdp-id [gre|mpls]
90
gre
Specifies that the SDP will use GRE to reach the far-end router. 90
mpls
Specifies the SDP will use MPLS encapsulation and one or more LSP
tunnels to reach the far-end router.
91
adv-mtu-override
Overrides the advertised VC MTU. 91
far-end
Configures the system IP address of the far-end destination router for
the SDP that is terminating services.
93
ldp
Enables LDP-signaled LSP's on MPLS-encapsulated SDPs. 94
lsp
Creates associations between one or more label switched paths (LSPs)
and an MPLS SDP.
94
path-mtu
Configures the Maximum Transmission Unit (MTU) in bytes that the
SDP can transmit to the far-end router without packet dropping the
SDP-type default path-mtu.
96
signaling
Enables the signaling protocol (targeted LDP) to obtain the ingress
and egress labels in frames transmitted and received on the SDP.
95
vlan-vc-etype
Specifies the VLAN VC EtherType. 96
no shutdown
Administratively enables the SDP. 79
Configuring SDP class forwarding parameters
config>service>sdp
class-forwarding
Enables the forwarding of a service packet over the SDP based on the
class of service of the packet.
92
fc
Creates an explicit association between a forwarding class and an LSP 92
multicast-lsp
Specifies the RSVP or static LSP in this SDP to use to forward VPLS
multicast and broadcast packets.
93
no shutdown
Administratively enables class forwarding. 79
Table 1: CLI Commands to Configure Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
