Internet Enhanced Services
7750 SR OS Services Guide Page 759
seconds — Specifies the time frame in seconds that is used to limit the number of “packet-too-big”
ICMP messages issued.
Values 1 — 60
Default 10
param-problem
Syntax param-problem [number seconds]
no packet-too-big
Context config>service>ies>if>ipv6>icmp6
Description This command specifies whether “parameter-problem” ICMP messages should be sent. When
enabled', “parameter-problem” ICMP messages are generated by this interface.
The no form of the command disables the sending of “parameter-problem” ICMP messages.
Default 100 10
number — Specifies the number of “parameter-problem” ICMP messages to send in the time frame
specified by the seconds parameter.
Values 10 — 1000
Default 100
seconds — Specifies the time frame in seconds that is used to limit the number of “parameter-
problem” ICMP messages issued.
Values 1 — 60
Default 10
redirects
Syntax redirects [number seconds]
no redirects
Context config>service>ies>if>ipv6>icmp6
Description This command configures ICMPv6 redirect messages. When enabled, ICMPv6 redirects are
generated when routes are not optimal on this router and another router on the same subnetwork has a
better route in order to alert that node that a better route is available.
When disabled, ICMPv6 redirects are not generated.
Default 100 10
number — Specifies the number of version 6 redirects are to be issued in the time frame specified by
the seconds parameter.
Values 10 — 1000
Default 100
To Next Page
Loading...
