IES Service Configuration Commands
Page 760 7750 SR OS Services Guide
seconds — Specifies the time frame in seconds that is used to limit the number of version 6 redirects
issued.
Values 1 — 60
Default 10
time-exceeded
Syntax time-exceeded [number seconds]
no time-exceeded
Context config>service>ies>if>ipv6>icmp6
Description This command specifies whether “time-exceeded” ICMP messages should be sent. When enabled,
ICMPv6 “time-exceeded” messages are generated by this interface.
When disabled, ICMPv6 “time-exceeded” messages are not sent.
Default 100 10
number — Specifies the number of “time-exceeded” ICMP messages are to be issued in the time
frame specified by the seconds parameter.
Values 10 — 1000
Default 100
seconds — Specifies the time frame in seconds that is used to limit the number of “time-exceeded”
ICMP message to be issued.
Values 1 — 60
Default 10
unreachables
Syntax unreachables [number seconds]
no unreachables
Context config>service>ies>if>ipv6>icmp6
Description This command specifies that ICMPv6 host and network unreachable messages are generated by this
interface.
When disabled, ICMPv6 host and network unreachable messages are not sent.
Default 100 10
number — Specifies the number of destination unreachable ICMPv6 messages are issued in the time
frame specified by the seconds parameter.
Values 10 — 1000
Default 100
seconds — Specifies the time frame in seconds that is used to limit the number of destination
unreachable ICMPv6 messages to be issued.
To Next Page
Loading...
