Alcatel-Lucent 7750 SR OS - Page 808

IES Service Configuration Commands
Page 808 7750 SR OS Services Guide
Syntax ingress-label start-label [end-label]
Context show>service
Description Display services using the range of ingress labels.
If only the mandatory start-label parameter is specified, only services using the specified label are
displayed.
If both start-label and end-label parameters are specified, the services using the range of labels X
where start-label <= X <= end-label are displayed.
Use the show router vprn-service-id ldp bindings command to display dynamic labels.
Parameters start-label — The starting ingress label value for which to display services using the label range. If
only start-label is specified, services only using start-label are displayed.
Values 0, 2048 - 131071
end-label — The ending ingress label value for which to display services using the label range.
Default The start-label value
Values 2049 - 131071
Output Show Service Ingress-Label — The following table describes show service ingress-label output
fields:
Sample Output
*A:ALA-12# show service ingress-label 0
==============================================================================
Martini Service Labels
==============================================================================
Svc Id Sdp Id Type I.Lbl E.Lbl
------------------------------------------------------------------------------
1 10:1 Mesh 0 0
1 20:1 Mesh 0 0
1 30:1 Mesh 0 0
1 50:1 Mesh 0 0
1 100:1 Mesh 0 0
1 101:1 Mesh 0 0
Label Description
Svc ID
The service identifier.
SDP Id
The SDP identifier.
Type
Indicates whether the SDP is a spoke or a mesh.
I.Lbl
The ingress label used by the far-end device to send packets to this
device in this service by the SDP.
E.Lbl
The egress label used by this device to send packets to the far-end
device in this service by the SDP.
Number of Bindings
Found
The number of SDP bindings within the label range specified.