IES Service Configuration Commands
Page 812 7750 SR OS Services Guide
sdp
Syntax sdp [sdp-id | far-end ip-address] [detail | keep-alive-history]
Context show>service
Description Displays SDP information.
If no optional parameters are specified, a summary SDP output for all SDPs is displayed.
Parameters sdp-id — The SDP ID for which to display information.
Default All SDPs.
Values 1 — 17407
far-end ip-address — Displays only SDPs matching with the specified far-end IP address.
Default SDPs with any far-end IP address.
detail — Displays detailed SDP information.
Default SDP summary output.
keep-alive-history — Displays the last fifty SDP keepalive events for the SDP.
Default SDP summary output.
Output Show Service SDP — The following table describes show service SDP output fields:
Label Description
SDP Id
The SDP identifier.
Adm MTU
Specifies the desired largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router, without requiring
the packet to be fragmented.
Opr MTU
Specifies the actual largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router, without requiring
the packet to be fragmented.
IP address
Specifies the IP address of the remote end of the GRE or MPLS
tunnel defined by this SDP.
Adm
Admin State
Specifies the desired state of the SDP.
Opr
Oper State
Specifies the operating state of the SDP.
Deliver
Specifies the type of delivery used by the SDP: GRE or MPLS.
Flags
Specifies all the conditions that affect the operating status of this SDP.
Signal
Signaling
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP.
Last Status Change
Specifies the time of the most recent operating status change to this
SDP.
To Next Page
Loading...
