EasyManua.ls Logo

Alcatel-Lucent 7750 SR OS - Page 813

Alcatel-Lucent 7750 SR OS
1506 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Internet Enhanced Services
7750 SR OS Services Guide Page 813
Sample Output
*A:ALA-12# show service sdp
==============================================================================
Services: Service Destination Points
==============================================================================
SdpId Adm MTU Opr MTU IP address Adm Opr Deliver Signal
------------------------------------------------------------------------------
10 4462 4462 10.20.1.3 Up Dn NotReady MPLS TLDP
40 4462 1534 10.20.1.20 Up Up MPLS TLDP
60 4462 1514 10.20.1.21 Up Up GRE TLDP
Last Mgmt Change
Specifies the time of the most recent management-initiated change to
this SDP.
Number of SDPs
Specifies the total number of SDPs displayed according to the criteria
specified.
Hello Time
Specifies how often the SDP Echo Request messages are transmitted
on this SDP.
Deliver/Delivered
Specifies the type of delivery used by the SDP: GRE or MPLS.
Hello Time
Specifies how often the SDP Echo Request messages are transmitted
on this SDP.
Hello Msg Len
Specifies the length of the SDP Echo Request messages transmitted
on this SDP.
Hello Timeout
Specifies the number of seconds to wait for an SDP echo response
message before declaring a timeout.
Unmatched Replies
Specifies the number of SDP unmatched message replies.
Max Drop Count
Specifies the maximum number of consecutive SDP Echo Request
messages that can be unacknowledged before the keepalive protocol
reports a fault.
Hold Down Time
Specifies the amount of time to wait before the keepalive operating
status is eligible to enter the alive state.
TX Hello Msgs
Specifies the number of SDP echo request messages transmitted since
the keepalive was administratively enabled or the counter was
cleared.
Rx Hello Msgs
Specifies the number of SDP echo request messages received since
the keepalive was administratively enabled or the counter was
cleared.
Associated LSP
List
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP
address specified in the Far End field.
If the SDP type is GRE, then the following message displays:
SDP Delivery Mechanism is not MPLS
Label Description

Table of Contents

Other manuals for Alcatel-Lucent 7750 SR OS

Related product manuals