IES Service Configuration Commands
Page 832 7750 SR OS Services Guide
Output Show DHCP Summary Output — The following table describes the output fields for DHCP
summary.
Sample Output
A:ALA-49# show service id 88 dhcp summary
===============================================================================
DHCP Summary, service 88
===============================================================================
Interface Name Arp Used/ Info Admin
SapId/Sdp Populate Provided Option State
-------------------------------------------------------------------------------
Sector A No 0/0 Keep Up
sap:7/1/1.2.2 0/0
grp-if No 0/1 Keep Down
sap:2/2/2:0 0/1
test No 0/0 Keep Up
sap:10/1/2:0 0/0
-------------------------------------------------------------------------------
Interfaces: 3
===============================================================================
A:ALA-49#
gsmp
Syntax gsmp
Context show>service>id
Description This command displays GSMP information.
neighbors
Label Description
Interface Name
Name of the router interface.
Arp Populate
Specifies whether or not ARP populate is enabled.
Used/Provided
Used — The number of lease-states that are currently in use on a spe-
cific interface, that is, the number of clients on that interface got an IP
address by DHCP. This value is always less than or equal to the ‘Pro-
vided’ field.
Provided — The lease-populate value that is configured for a spe-
cific interface.
Info Option
Indicates whether Option 82 processing is enabled on the interface.
Admin State
Indicates the administrative state.
To Next Page
Loading...
