Virtual Private Routed Network Services
7750 SR OS Services Guide Page 881
customer
Specifies the existing customer ID number to be associated with the
service.
954
Configure VPRN service parameters
config>service>vprn
description
Specifies a text string describing the service. 952
auto-bind
Specifies the automatic binding type for the SDP assigned to this
service.
955
autonomous-system
Defines the autonomous system (AS) to be used by this VPN routing/
forwarding (VRF).
955
ecmp
Enables ECMP and configures the number of routes for path sharing. 955
gsmp
Enables the context to configure GSMP connections maintained in this
service.
956
group
Specifies a GSMP name. 956
ancp
Configures ANCP parameters for this GSMP group. 956
dynamic-topology-
discover
Enables the ANCP dynamic topology discovery capability. 956
oam
Specifies GSMP ANCP OAM negotiation at the start of a GSMP
connection.
957
hold-multiplier
Configures the hold-multiplier for the GSMP connection in this group. 957
keep-alive
Configures keepalive values for the GSMP connection in this group. 957
neighbor
Adds or removes a neighbor from this GSMP group. 957
local-address
Configures the source IP address. 958
priority-marking
Configures the type of poriority marking. 958
igmp
Enables the context to configure IGMP connections maintained in this
service.
958
maximum-routes
Specifies the maximum number of routes that can be held within a
VPN routing/forwarding (VRF) context.
965
mc-maximum-routes
Specifies the maximum number of multicast routes that can be held
within a VPN routing/forwarding (VRF) context.
966
route-distinguisher
Sets the identifier attached to routes the VPN belongs to. 967
router-id
Sets the router ID for a specific VPRN context. 967
snmp-community
Sets the SNMP community name to be used with the associated VPRN
instance.
967
static-route
Creates static route entries for network and access routes. 968
type
Designates the type of VPRN instance being configured for hub and
spoke topologies.
970
Table 1: CLI Commands to Configure VPRN Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
