Virtual Private Routed Network Services
7750 SR OS Services Guide Page 889
ingress
Configures ingress ATM attributes for the SAP. 1006
oam
Enables the context to configure OAM functionality for a PVCC
delimiting a SAP.
1006
alarm-cells
Configures AIS/RDI fault management on a PVCC. 1007
periodic-loopback
Enables periodic OAM loopbacks on this SAP. 1007
Configure VPRN interface DHCP parameters
config>service>vprn>if>dhcp
dhcp
Configures DHCP parameters for this interface 987
description
Specifies a text string description for DHCP on this interface. 952
gi-address
Configures the gateway interface address for the DHCP relay. 988
lease-populate
Enables dynamic host lease state management for VPRN IP interfaces. 988
option
Configures DHCP Option 82 processing for this interface. 1007
server
Configures the DHCP server IP address. 993
no shutdown
Enables DHCP on this interface. 951
trusted
Enables relaying of untrusted packets. 993
config>service>vprn>if>dhcp>option
action
Configures the DHCP relay reforwarding policy action. 987
circuit-id
Enables sending of the interface index in the circuit-id suboption of the
DHCP relay packet.
987
remote-id
Enables sending of the remote MAC address in the remote-id
suboption of the DHCP relay packet.
990
To configure interface ICMP parameters:
904
config>service>vprn service-id>interface
icmp
Configures ICMP parameters on an VPRN IP interface. 997
mask-reply
Enables responses to ICMP mask requests on the router interface. 997
redirects
Enables and configures the rate for ICMP redirect messages issued on
the router interface.
997
unreachables
Enables and configures the rate for ICMP host and network destination
unreachable messages issued on the router interface.
998
ttl-expired
Configures the rate ICMP TTL expired messages are issued by the IP
interface.
998
Configure VPRN interface VRRP parameters
config>service>vprn>interface>vrrp
Table 1: CLI Commands to Configure VPRN Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
