Configuring a VPRN Service with CLI
Page 888 7750 SR OS Services Guide
scheduler
Defines bandwidth controls that limit each child (other schedulers and
queues) associated with the scheduler.
1029
scheduler-policy
Associates an existing scheduler policy to an egress scheduler used by
SAP queues associated with this multi-service customer site.
1021
Configure SAP ingress parameters
config>service>vprn>if>sap>ingress
filter
Associates an IP or MAC filter policy with an ingress SAP or IP
interface.
1016
match-qinq-dot1p
Configures filtering based on the p-bits in the top or bottom tag of a Q-
in-Q encapsulated Ethernet frame.
1016
qos
Associates a Quality of Service (QoS) policy with an ingress SAP or IP
interface.
1020
queue-override
Enables the context to configure override values for the specified SAP
egress QoS queue.
1023
queue
Specifies the ID of the queue whose parameters are to be overridden. 1023
adaptation-rule
Overrides specific attributes of the specified queue’s adaptation rule
parameters.
1023
cbs
Overrides specific attributes of the specified queue’s CBS parameters. 1026
high-prio-only
Overrides specific attributes of the specified queue’s high-prio-only
parameters.
1026
mbs
Overrides specific attributes of the specified queue’s MBS parameters. 1027
rate
Overrides specific attributes of the specified queue’s Peak Information
Rate (PIR) and the Committed Information Rate (CIR) parameters.
1028
scheduler-override
Specifies the set of attributes whose values have been overridden via
management on this virtual scheduler.
1029
scheduler
Defines bandwidth controls that limit each child (other schedulers and
queues) associated with the scheduler.
1029
scheduler-policy
Associates an existing scheduler policy to an ingress scheduler used by
SAP queues associated with this multi-service customer site.
1021
Configure VPRN interface SAP ATM parameters 917
config>service>vprn>interface>sap
atm
Enables access to the context to configure ATM-related attributes. 1005
egress
Configures egress ATM attributes for the SAP. 1005
traffic-desc
Assigns an ATM traffic descriptor profile to a given context (for
example a SAP).
1006
encapsulation
Configures RFC 2684 encapsulation for an ATM PVCC delimited
SAP.
1005
Table 1: CLI Commands to Configure VPRN Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
