Alcatel-Lucent 7750 SR - Page 348

VLL Service Configuration Commands
Page 348 7750 SR OS Services Guide
config>service>ipipe>sap>eth-cfm>mep
Description This command enables the context to configure ETH-CFM parameters.
mep
Syntax mep mep-id domain md-index association ma-index [direction {up | down}]
no mep mep-id domain md-index association ma-index
Context config>service>epipe>sap>eth-cfm
config>service>ies>sub-if>eth-cfm
config>service>epipe>spoke-sdp>eth-cfm
DescriptionThis command provisions an 802.1ag maintenance endpoint (MEP).
The no form of the command reverts to the default values.
Parameters mep-id — ppecifies the maintenance association end point identifier.
Values 1 — 81921
md-index — Specifies the maintenance domain (MD) index value.
Values 1 — 4294967295
ma-index — Specifies the MA index value.
Values 1 — 4294967295
direction up | down — Indicates the direction in which the maintenance association (MEP or MIP)
faces on the bridge port.
down — Sends continuity check messages away from the MAC relay entity.
up — Sends continuity check messages towards the MAC relay entity.
ais-enable
Syntax [no] ais-enable
Context config>service>epipe>sap>eth-cfm>mep
config>service>epipe>spoke-sdp>eth-cfm>mep
Description This command enables the generation and the reception of AIS messages.
client-meg-level
Syntax client-meg-level [[level [level ...]]
no client-meg-level
Context config>service>epipe>spoke-sdp>eth-cfm>mep>ais-enable
config>service>epipe>sap>eth-cfm>mep>ais-enable