Chapter 2: Fusion Basics
2
29
Rewind to Beginning/Fast Forward to End
[Press LOCATE + REW to return to the beginning of a song]
[Press LOCATE + FFWD to jump to the end of a song]
When working in Song mode, you may want to rewind to the
beginning of a song or to fast-forward to the end of the song.
To rewind, press LOCATE and REW at the same time. To
fast-forward, press LOCATE and FFWD at the same time.
Return to Default Settings
[Hold INC + DEC buttons]
Each parameter has a designated “default” setting. If you’ve
changed a parameter and you’d like to return to its “default”
settings, press both INC and DEC buttons at the same time.
Setting Parameter Values Quickly
[Hold LOCATE + keyboard note]
A useful shortcut for setting parameter values is to use the
LOCATE key and press a note on the keyboard. If you have
selected a parameter that accepts either positive or negative
values, then middle C corresponds to zero and values become
larger (or smaller) as you get farther away from middle C. If
the parameter only accepts positive values, then the lowest note
on the keyboard selects the lowest value that is available for the
parameter.
EDIT/COMPARE Modes
[Press EDIT when you are in EDIT mode]
If you’ve changed any parameters and would like to compare
your changes with the original settings in the saved program,
mix, song, or sample, press EDIT once and you will be taken
into “Compare” mode. Press the EDIT button again to be
taken back to your current settings. This button lets you quickly
compare your changes to what has been saved.
Note that the text at the top of the screen changes from “Edit”
to “Comp” as you jump between edit and compare modes.
Also note that you cannot change any of the settings when you
are Compare mode—the mode is only provided as a reference.
Finally, once you save your updated parameter settings, you can
no longer compare your current program, mix, song, or sample
since your current settings have overwritten the old ones.
To Next Page
Loading...
Need help?
General
