Table 26. System Setup options—Integrated Devices menu(continued)
Integrated Devices
Enable Rear USB Ports Enables the rear USB ports.
By default, the Enable Rear USB Ports option is enabled.
NOTE: To view this option, enable Advanced Setup mode as described in View
Advanced Setup options.
Enable USB Boot Support Enables booting from USB mass storage devices that are connected to external USB
ports.
By default, the Enable USB Boot Support option is enabled.
NOTE: To view this option, enable Advanced Setup mode as described in View
Advanced Setup options.
Enable Thunderbolt Technology Support
Enable Thunderbolt Technology Support Enables the associated ports and adapters for Thunderbolt Technology support.
By default, the Enable Thunderbolt Technology Support option is enabled.
NOTE: To view this option, enable Advanced Setup mode as described in View
Advanced Setup options.
Enable Thunderbolt Boot Support
Enable Thunderbolt Boot Support Enables the Thunderbolt adapter-peripheral device and USB devices that are
connected to the Thunderbolt adapter to be used during BIOS Preboot.
By default, the Enable Thunderbolt Boot Support option is disabled.
NOTE: To view this option, enable Advanced Setup mode as described in View
Advanced Setup options.
Dust Filter Maintenance
Dust Filter Maintenance Enables or disables BIOS messages for maintaining the optional dustfilter that is
installed in your computer. BIOS generates a pre-boot reminder to clean or replace
the dust filter based on the interval set.
By default, the Dust Filter Maintenance option is disabled.
NOTE: To view this option, enable Advanced Setup mode as described in View
Advanced Setup options.
Table 27. System Setup options—Storage menu
Storage
SATA/NVMe Operation
SATA/NVMe Operation Sets the operating mode of the integrated SATA hard drive controller.
By default, the RAID On option is selected.
Storage Interface Displays the information of various onboard drives.
Port Enablement Enables or disables the M.2 PCIe SSD option.
SMART Reporting Enables or disables the SMART Reporting option.
By default, the Enable SMART Reporting option is disabled.
NOTE: To view this option, enable Advanced Setup mode as described in View
Advanced Setup options.
Drive Information Displays the information of onboard drives.
BIOS Setup 149
To Next Page
Loading...
