Figure 67. Removing the wireless card
Steps
1. Lay the computer on the right side.
2. Remove the screw (M2x3.5) that secures the wireless card and wireless-card bracket to the system board.
3. Lift the wireless-card bracket off the wireless card.
4. Disconnect the SMA cables from the wireless card.
5. Slide and remove the wireless card from the wireless-card slot on the system board.
Installing the wireless card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
CAUTION: To avoid damage to the wireless card, do not place any cables under it.
About this task
The following images indicate the location of the wireless card and provide a visual representation of the installation procedure.
82 Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
