About this task
The following images indicate the location of the coin-cell battery and provide a visual representation of the removal procedure.
Figure 65. Removing the coin-cell battery
Steps
1. Lay the computer on the right side.
2. Press the battery-release lever away from the coin-cell battery until the coin-cell battery pops up.
3. Slide and lift the coin-cell battery out of the coin-cell battery slot.
Installing the coin-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the coin-cell battery and provide a visual representation of the installation procedure.
80 Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
