NOTE: To install the operating system on to your storage device, see Reinstall Windows to the Dell factory image using
recovery media in the Knowledge Base Resource at Dell Support Site.
Coin-cell battery cover
Removing the coin-cell battery cover
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left cover.
About this task
NOTE: The coin-cell battery cover is designed to prevent children from accessing the coin-cell battery. The coin-cell battery
cover does not affect the computer's functionality.
The following images indicate the location of the coin-cell battery cover and provide a visual representation of the removal
procedure.
Figure 63. Removing the coin-cell battery cover
Steps
1. Lay the computer on the right side.
2. Using your fingertips, press the edges of the coin-cell battery cover on both the sides.
3. Release the coin-cell battery cover from the coin-cell battery slot on the system board.
4. Lift the coin-cell battery cover away from the coin-cell battery slot.
Installing the coin-cell battery cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
78 Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
