Rapid Advance Feature
The
Rapid Advance feature allows the owner to
quickly advance through active cycles
or
advance into
a cycle from the ready mode.
How
to
Enter Rapid Advance
1.
If
control is
in
Ready Mode, control must
be
put
into Manual Mode. Refer to Entering the
Manual Mode.
2. Press the DELICATESIBULKY
0)
or
the
COLD
(v)
keypad until "rAPd" appears
in
the
display.
3. Press the START (enter) keypad.
The
display will
show "PUSH" then "Strt" followed
by
the cycle
time and the START (enter) keypad LED will
flash.
4. Press the START (enter) keypad to start cycle.
NOTE:
Door
must
be
closed
to
start
cycle.
How
to
Enter Rapid Advance During
an Active Cycle
1.
Be
certain service door is open.
2. While pressing and holding the NORMAL
keypad with one hand, press the
HOT
keypad
with the other hand.
3. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad until "rAPd" appears in the
display.
4. Press START (enter) to activate rapid advance
cycle.
Control may
be
in an active cycle
or
in the ready mode
to use the Rapid Advance feature.
While in the Rapid Advance Mode, pressing the
START (enter) keypad will advance the washer to the
next cycle step.
The
cycle indicator lights will tell
which cycle step the washer is in.
For
Example:
If
the washer is
in
the first fill/agitate
cycle step, pressing the START (enter) keypad will
advance the washer into the Wash DrainlDistribute
cycle step.
Continue pressing the START (enter) keypad until the
cycle is completed.
How
to
Exit Rapid Advance Feature
1.
Advance through
the
cycles until reaching the
ready mode.
NOTE:
The
Rapid
Advance
option
must
be
turned
on
for
Rapid
Advance
to
work.
Refer
to
option
35
in
Programming Control.
802952
@ Published by permission of
the
copyright owner - DO NOT
COpy
or TRANSMIT
97
To Next Page
Loading...
