Dryer Operation
Start Up
When power is applied to the dryer, the control
becomes active and will display its software version as
"SXX" ("XX" is the version number) for one second
and then the subversion as
"XX"
(if
subversion
isn't
zero) for one second.
If
the control was not powered
down during a running cycle, it will enter the Ready
Mode.
Ready Mode
In Ready Mode, the default cycle LED is lit, and the
full vend price is displayed.
The user may select a different cycle,
if
desired.
If
the
vend price is not satisfied within 4.25 minutes, the
dryer control will return to the Ready Mode. The
display will continue to show the remaining vend
needed to start a cycle.
Partial Vend Mode
The control enters this mode when part
of
the vend
price has been entered, but not enough vend is entered
to satisfy the vend price. The control will display the
remaining vend price needed to start the cycle and the
INSERT COINS/CARD LED is
lit.
Additional Vend Mode
The control enters this mode
if
the cycle is changed to
a cycle that requires more money.
If
the vend price is
not satisfied within 60 seconds, the control will go
back to the first selection and the cycle will continue.
Start Mode
Vends may
be
satisfied
by
a coin drop, start pulses, or
by
a third party card reader.
If
a coin drop is used, the
remaining vend price will decrease with each coin
entry.
If
start pulses are used, the remaining vend price
will decrease with each received pulse. Once the vend
is satisfied, the START LED will begin to flash and
signal will sound for ten seconds.
If
a third party card
reader is used, the START LED will begin to flash
when a valid cash card is entered into the reader.
When the
START keypad is pressed, the dryer will
start. The START LED will stop flashing and either
the DRYING LED
or
the COOL DOWN LED will
be
lit.
The
display will change to show the remaining
cycle time on the display.
The
DRYING LED will
be
lit during the heat portion
of
a heat cycle. The COOL
DOWN
LED will
be
lit during the cool down portion
of
a heat cycle and during an entire no heat cycle.
When a cycle is complete, the display will show "00"
until the door is opened, a key is pressed, a coin or
card is entered, or a start pulse is received. When any
of
the above happens, the display will revert back to
the Ready Mode.
Entering Coins
Coins are entered to satisfy the programmed vend
price for a selected cycle. Coins may
be
entered before
selecting a cycle
or
during
an
active cycle. When coins
are entered during an active cycle, the time remaining
is increased
by
the amount programmed
by
the owner
(refer to
Programming Control).
The
owner
may
choose to add additional time for each
coin entered.
If
coins are entered for an active cycle
currently in the COOL
DOWN
Mode, coins entered
may push the cycle back into the DRYING Mode. The
maximum time for any cycle is 99 minutes.
8
©
Published
by
permission
of
the
copyright owner - DO NOT
COpy
or TRANSMIT
513001
To Next Page
Loading...
