Special Features
Programming Control
The control allows the dryer owner to program the
control with the use
of
the keypad. Cycle and vend
information may
be
programmed, audit information
may
be
viewed and diagnostic tests
may
be
run
by
pressing keypad combinations.
For details on programming cycle and vend information,
refer to
Programming Control.
Collecting Audit Information
The control will store audit information in its memory
that
can be retrieved
by
pressing various keypad
combinations. The control will record coins entered,
total machine cycles, top-offs, and total start pulses.
For more information on the audit features, refer to
Collecting
Audit
Information.
NOTE:
Additional
audit
information is retrievable
with
an
external device, a
card
reader
or
a
network. Refer to
the
appropriate
instruction
manual.
Testing Machine and Control
Functions
Special programmable diagnostic features built into
the control allow the owner to run specific diagnostic
tests.
By
opening and closing the service door, with
coin vault closed, and then pressing various sequences
of
keypads, the owner may retrieve and perform the
following tests:
A Control Software Version Number
A Service Door Opening Test
A Coin Vault Opening Test
A Coin Drop
#1
Input Test
A Coin Drop #2 Input Test
A Start Pulse Test
A Dryer-on Temperature Test
A Thermistor Temperature Test
A Configuration Display Tests
A Coin Header Present Status
For detailed information on running diagnostic tests,
refer to
Testing Machine
and
Electronic Control
Functions.
Rapid Advance Feature
This feature allows the user to quickly advance
through an active dryer cycle
or
advance into a cycle
from the Ready Mode. This feature is useful when
tests must
be
performed immediately
on
a dryer
currently in an active cycle. In this case, the user can
quickly advance through the cycle to the Ready Mode.
At
this point, the user can perform the required tests
and then return the dryer to the active cycle.
For
detailed information
on
using the Rapid Advance
feature, refer to
Rapid Advance Feature.
Clearing the Vend Feature
This feature allows the user
to
return the control
back
to the Ready Mode
if
coins have been entered but the
full vend price has not yet been satisfied, while in
Partial Vend Mode.
For more information on using the Clear Vend feature,
refer to
Clear Pend Feature.
Communications Mode
This feature allows the dryer control to communicate
with
an
external device, a card reader
or
a network.
This allows the dryer control to be programmed and
have its data read without using the keypad.
For
more detailed information on using the
Communications Mode feature, refer
to
Communications Mode.
Coin Drop
The
control will accept pulses from a single or dual
coin drop to satisfy vend price. Each coin drop will
have the ability to satisfy the vend.
513001
10
© Published
by
pennission
of
the
copyright owner -
DO
NOT
COPY
or
TRANSMIT
To Next Page
Loading...
